Loxeal Activator 9 Cyanoacrylate Accelerator Spray 200ml

Designed to be used with Loxeal super glues: Speeds the cure of Istant 23 Fluid, Istant 25 Medium, Istant 27 High Viscosity and Istant 43 Speciale. Loxeal Activator 9 Cyanoacrylate Accelerator Spray 200ml Loxeal Activator 9 is an accelerator spray for cyanoacrylate super glues that cleans and degreases parts while slashing setting times. Sprayed onto one surface before assembly, it triggers cure in just 1-4 seconds – even on slow, dry or hard-to-activate substrates – and a treated surface stays active for up to 8 hours. It can also be misted over squeezed-out adhesive after assembly to fix the excess instantly. Supplied as a 200ml aerosol for fast, even coverage. Why choose Loxeal Activator 9? Cure in 1-4 seconds – turns slow joints into instant ones Cleans as it works – degreases parts in the same step 8-hour activation window – pre-treat parts ahead of assembly Fixes surplus glue – instantly sets excess adhesive outside the joint Convenient aerosol – quick, even application on parts of any shape Typical applications Speeding up cyanoacrylate cure on wood, porous and acidic surfaces Production assembly where consistent, rapid fixture times matter Cold or low-humidity conditions where super glue sets slowly Instantly curing glue fillets and squeeze-out for a tidy finish How to use Spray a light coat of Activator 9 onto one of the surfaces to be bonded. Allow it to dry for 20-30 seconds. Apply cyanoacrylate adhesive to the other surface and assemble the parts – cure takes effect in 1-4 seconds. To set surplus adhesive after assembly, mist it lightly with Activator 9. Usage notes Exact curing effect depends on the adhesive type, gap between parts and surface composition. Treated surfaces remain active for around 8 hours, so parts can be prepared in advance. Note that heavy over-application of activator can reduce ultimate bond strength on some joints. Specifications Chemistry Organic chemicals in solvent composition Appearance Colourless Viscosity (+25°C) 1-2 mPa·s Drying time (+25°C) 20-30 seconds Cure effect 1-4 seconds, adhesive and gap dependent Activation life on surface 8 hours Shelf life 12 months in original unopened packaging Pack size 200ml aerosol spray Important notes Solvent based aerosol – use in a well-ventilated area away from heat and ignition sources. Store in a cool, dry place below +20°C and do not refill containers with used product. Pair with Loxeal Istant cyanoacrylate adhesives for best results. Safety Consult the Safety Data Sheet (SDS) before use. Pressurised container – protect from sunlight and do not expose to temperatures exceeding +50°C. This information is provided as a general guide only. Always test on your specific materials and refer to the manufacturer’s technical documentation before use.